Carports

The State Policy identifies the specific standards for a carport development to be exempt from planning consent.

Did you know you may be able to build a carport without planning approval?

It cannot be constructed on land that is:

  • in a foreshore area
  • on or in a heritage item
  • on or in a draft heritage item.

The maximum size allowed

The floor area of a carport must not exceed:

  • 20 m2 on lots with an area of 300 m2 or less.
  • 25 m2 for lots larger than 300 m2 in other zones.
  • 50 m2 for lots larger than 300 m2 in rural zones and residential Zone R5.
  • The carport must not be higher than 3 m above ground level (existing), and if it is attached to a single storey dwelling, not higher than the roof gutter line of that dwelling.
  • At least 2 sides and one-third of the carport’s total perimeter must be open.

Where you can build them on your lot

Carports must be at least 1 m behind the building line facing any road ( the building line is the face of a building’s outer wall (not including any ancillary or attached structures)).

Figure 1 illustrates the requirements. The carport must be set back:

  • At least 5 m from any lot boundary in zones RU1, RU2, RU3, RU4, RU6, R5.
  • At least 900 mm in any other zone.
  • At least 1 m behind the building line, facing any road.
  • In heritage conservation areas (or draft conservation areas), carports must be in the rear yard.
  • The roof of the carport may project into the required setback area, but it must be setback at least 500 mm from any lot boundary.
Figure 1

More than one carport on a lot

If a lot has one house, only one carport is permitted. Where there is a primary and secondary dwelling, 2 carports may be allowed on the lot.

Read the full development standards that a carport must meet to be exempt development in the State Policy.

Other standards that apply

On bushfire-prone land, carports must be constructed of non-combustible materials if it is within 5m of a dwelling.

Roof water from the carport must be disposed of into an existing stormwater drainage system.

Any connection to a building fascia must be done in accordance with a professional engineer’s specifications.

Works must not reduce vehicle access to or from the site or reduce existing car parking, or loading/unloading facilities.

Any metal materials must be low reflective, factory pre-coloured materials.

One carport per dwelling

For residential exempt development, you can only have one carport for every dwelling house on the lot. For instance, if the lot has one dwelling house, there can only be one carport on that lot. If there is a primary and secondary dwelling on the lot, you can have 2 carports.

Other considerations

Find out if you are on a bushfire prone land using the NSW Planning Portal Spatial Viewer.

Before removing or pruning any existing trees or vegetation, check with your council whether you need approval.

All works must be structurally adequate, installed in accordance with manufacturer’s specifications and comply with the Building Code of Australia (BCA).

Any structure on or over public land or roads must have approval specifically from the local council or Transport for NSW under the Roads Act 1993 and the Local Government Act 1993.

Generally, exempt development cannot be carried out on:

Garages

Carports and garages can be built as complying development as attached and detached development.

To be complying development, the new carport or garage must not result in the development on the lot exceeding the gross floor area.

In residential zones

Carports and garages can only be built as complying development on lots zoned residential R1, R2, R3, R4 and rural zone RU5, that have:

  • an area of at least 200 m2
  • a width of at least 6 m.

The carport or garage must comply with the following development standards:

  • Garages can only be built on lots that are less than 8 m wide when the vehicle access is from a secondary road, parallel road or lane (not the primary road).

The maximum permitted height for detached garages or carports is 4.5 m above ground level (existing).

  • If vehicle access is on a primary road, the carport or garage must be set back at least 5.5 m or 1 m behind the building line, dependent on front setback from the boundary with the primary road.
  • The total width of all garage door openings that face a road must not exceed:
    • 3.2 m on lots that are between 8 m and 12 m wide, or
    • 6 m on lots that are more than 12 m wide.
  • The location of carports and garages on battle-axe lots must allow vehicles to exit the site in a forward direction.

Other items to consider

  • If a new driveway or gutter crossing is required, you must get separate approval from council or the Roads and Maritime Services under the Roads Act 1993.
  • New driveways must be constructed in accordance with Australian Standard 2890.1 – 2004 Parking Facilities – off-street car parking.
  • If you propose to do any cut or fill, the works must comply with the requirements for cut and fill for exempt development or complying development.
  • If you propose to remove or prune any existing trees or vegetation, you should contact your council first. You may need approval.
  • If any structures will be located on public land, or on or over a public road (including temporary structures), you will need to get separate approval from the relevant council or Roads and Maritime Services under the Roads Act 1993 and the Local Government Act 1993.

If your proposal does not meet the required standards for exempt or complying development, you may still be able to do the work, but you must get development approval first. In this case, you should contact your local council to discuss your options.

More information

For more information, email the Codes team at [email protected]